Layered Brushstrokes Pattern pattern roller blind

Custom roller blinds are a modern and inexpensive alternative to decorate any window. The installation and assembly of Tensticker blinds is very easy, you can do it yourself without investing too much effort and time. Please note that our blinds come fully assembled and only require installation of the brackets.

1. Ruler and carpenters ruler.

2. Spirit level

3. Drill to make fixing holes.

4. Hammer and screwdriver

5. Screws and dowels for fixing the blind support.

Before installing the blinds, keep in mind that you must use dowels and screws appropriate to the chosen surface and place of instalation. Make sure to leave enough room to avoid the blinds getting in the way of the window handles when the blinds are up. You must also take into account the position of the furniture and radiators. Finally, remember to measure the same distance on both sides of the window:

1. Choose the location and position of the supports and mark with a pencil the points where the two blind supports will be joined with a screw, taking into account the measurements indicated above. With the help of a tape measure, a long ruler or a strip and a spirit level mark both points, so that both supports are completely straight. Leave enough room to open the window when the blind is up.

2. Drill the holes for the dowels. Once you have drilled the holes with the corresponding drill bit, insert the plugs into the wall with the help of a hammer and screw the two brackets into the wall, in the corresponding holes.

3. Finally, insert the roller blind into the respective notches of each bracket. This mechanism is very easy to assemble, and allows you to remove or replace a roller blind very quickly, without any effort.